Everything below concerns Electrospray ionization. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Updated 2026-08-01. Numbers and descriptions here follow the published literature rather than marketing material.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It corresponds to the ACTH(4-7) fragment extended at the C-terminus by a Pro-Gly-Pro tripeptide, an addition intended to slow enzymatic breakdown. The molecular formula is C37H51N9O10S and the molecular mass is approximately 814 daltons. In the literature it is often described as an ACTH(4-10) analog, although that label reflects a naming convention as much as a precise structural relationship. The compound was developed in Russia and remains most closely associated with that research tradition.
Laboratory descriptions of the material are consistent across suppliers. It appears as a white to off-white lyophilized powder that dissolves readily in water and in polar organic solvents such as dimethyl sulfoxide. Aqueous solutions are clear and colorless at low concentrations. Because the peptide contains methionine, oxidation at the sulfur atom is a recognized degradation pathway, and handling notes usually call for protected, desiccated storage. Reported purity for research-grade lots is generally above 95 percent as measured by reversed-phase high-performance liquid chromatography.
The compound is registered in Russia as a pharmaceutical product, most commonly formulated as a nasal solution, and has been used in that setting since the 1990s. Outside that jurisdiction it is generally handled as a research chemical rather than an approved medicine. Regulatory status therefore differs sharply between countries, and material sold internationally may not correspond to the Russian pharmaceutical formulation. Documentation with commercial samples is typically limited to a certificate of analysis covering purity and identity, not clinical status or local legal classification.
Stability depends heavily on physical state. Lyophilized powder held dry, cold and dark retains its content over long periods, whereas dissolved peptide begins to change within days at room temperature. The most cited degradation route is oxidation of the methionine residue, which converts the peptide to a sulfoxide form that elutes differently on chromatography. Hydrolysis of amide bonds and adsorption onto container walls contribute smaller losses. Buffers that exclude oxygen from the headspace slow the oxidation pathway, but no single condition prevents all change indefinitely.
Practical handling follows from those properties. Bulk material is best divided into single-use portions soon after receipt, because each thaw exposes the whole container to moisture and temperature cycling. Vials should be allowed to reach room temperature before opening to prevent condensation on the powder. Low-binding plasticware reduces loss of dilute solutions, and sterile filtration is used when a preparation must remain free of microbial growth. Records of batch number, reconstitution date and storage history are what allow a later analytical result to be interpreted meaningfully.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C37H51N9O10S | Contains one methionine sulfur atom |
| Molecular mass | Approximately 814 Da | Consistent with a seven-residue peptide |
| Appearance | White to off-white powder | Typical lyophilized form |
| Solubility | Freely soluble in water | Also soluble in dimethyl sulfoxide |
| Typical storage | -20 °C, desiccated | Limits methionine oxidation |
Reported pharmacological work centers on neurotrophic signaling, including changes in BDNF and NGF expression in hippocampal tissue in animal models. Human data come largely from studies conducted in Russia, and how well those results generalize to other populations remains an open question. Regulatory status differs sharply by jurisdiction: Semax is a registered prescription medicine in Russia, while it holds no approved marketing status in the United States or the European Union. Outside such jurisdictions it is generally handled as a research chemical, which affects both documentation and quality expectations.
Semax is a synthetic heptapeptide whose sequence is Met-Glu-His-Phe-Pro-Gly-Pro. It was developed as a fragment analog of adrenocorticotropic hormone, modeled specifically on the ACTH(4-10) region. The first four residues reproduce that fragment, while a Pro-Gly-Pro tripeptide is appended at the C-terminus. Work on the compound originated in Russia, where it entered clinical use as an intranasal preparation. Its sequence places it among short regulatory peptides studied for effects on the central nervous system rather than on the adrenal axis.
The C-terminal Pro-Gly-Pro extension is not incidental. Proline-rich tails are known to resist several common peptidases, and the published literature attributes the longer half-life of Semax, relative to unmodified ACTH fragments, to this feature. The modification also removes the melanocyte-stimulating and corticosteroidogenic activity that characterizes longer ACTH-derived sequences. Because the molecule is small and hydrophilic, it is typically formulated as an aqueous solution for intranasal or parenteral delivery. Acetylation or amidation at the termini appears in closely related research peptides and shifts the mass by a fixed increment.
Common degradation pathways include oxidation of the methionine side chain, hydrolysis of the peptide backbone, and aggregation under unfavourable pH or concentration. Stability studies typically monitor the main peak by chromatography and report total related substances as a percentage. Because no official monograph exists, acceptance criteria vary between laboratories, and reported purity values are not directly comparable across suppliers. Analysts therefore document the method, column, and detection wavelength alongside each result, and open questions remain about how much biological activity the oxidised forms retain.
Solid semax is typically supplied as a lyophilised powder that is hygroscopic and sensitive to moisture, light, and repeated temperature cycling. Long-term storage of the dry peptide is generally recommended at approximately -20 degrees Celsius, while shorter working periods may use refrigeration at 2 to 8 degrees Celsius. Vials should remain tightly closed and desiccated when brought to room temperature, because condensation can damage the material before it is weighed. Dividing a batch into aliquots is preferable to thawing one container repeatedly.
研究兴趣主要集中在神经营养因子相关的路径上，包括脑源性神经营养因子与神经生长因子的表达变化。部分实验报告称在特定条件下观察到这些因子的水平上升，但具体信号通路和剂量依赖关系仍未完全厘清。多数公开数据来自细胞模型和动物实验，人体对照研究数量有限。因此，该化合物的作用机制在文献中属于活跃讨论，而非已经确立的定论。
Semax 是一种人工合成的七肽，氨基酸序列为 Met-Glu-His-Phe-Pro-Gly-Pro，单字母缩写记作 MEHFPGP。它被归类为促肾上腺皮质激素片段 ACTH(4-10) 的结构类似物，但并不天然存在于生物体内。母体片段 ACTH(4-10) 的序列为 Met-Glu-His-Phe-Arg-Trp-Gly，Semax 替换了中间两个残基，并在羧基端延长了 Pro-Gly-Pro 三肽。这种延长被普遍认为能提升分子对肽酶的耐受性。
该化合物于二十世纪八十年代在俄罗斯被开发，相关工作由俄罗斯科学院分子遗传学研究所的研究团队主导。开发目标并非复制 ACTH 的完整激素活性，而是寻找保留其神经作用方向、同时去除促肾上腺皮质激素释放效应的短肽片段。研究记录显示，这一方向促成了多个相关短肽的合成与筛选，而 Semax 是其中被研究最广泛的一个。当地文献常以 Семакс 这一名称指代它。
Feoktist I. Bogoyavlenskiy (1933–1935) Vasiliy V. Evlampiev (1935–1939) Faizi F. Faizyllin (1958–1960) Boris A. Arbuzov (1941–1950) Arkadiy N. Pudovik (1950–1958) Faizi F. Faizyllin (1958–1960) Vera F. Toropova (1960–1965) Alexander I. Kostromin (1965–1968) Alexander I. Konovalov (1968–1972) Irina V. Konovalova (1972–1987) Galina A. Chmutova (1987–1992) Nikolai A. Ulakhovich (1992–2000) Vladimir I. Galkin (since 2000– until present) Department of Analytical Chemistry Department of High Molecular and Organoelement Compounds Department of Inorganic Chemistry Department of Organic Chemistry Department of Physical Chemistry Department of Chemical Education Department of Environmental Chemistry Department of Applied Chemistry Department of Stereochemistry Division for Analytical Chemistry Division for Inorganic Chemistry and Coordination chemistry Division for Organic Chemistry Division for Physical Chemistry Division for Organoelement Compounds Division for Stereochemistry Division for Applied Chemistry Division for Environmental Chemistry
234U has a neutron capture cross section of about 100 barns for thermal neutrons, and about 700 barns for its resonance integral—the average over neutrons having various intermediate energies. In a nuclear reactor, non-fissile isotopes capture a neutron breeding fissile isotopes. 234U is converted to 235U more easily and therefore at a greater rate than uranium-238 is to plutonium-239 (via neptunium-239), because 238U has a much smaller neutron-capture cross section of just 2.7 barns.
IATA estimates that over a billion lithium metal and lithium-ion cells are flown each year. Some kinds of lithium batteries may be prohibited aboard aircraft because of the fire hazard. Some postal administrations restrict air shipping (including EMS) of lithium and lithium-ion batteries, either separately or installed in equipment.
=== Management === Various methods can be used to manage backup media, striking a balance between accessibility, security and cost. These media management methods are not mutually exclusive and are frequently combined to meet the user's needs. Using on-line disks for staging data before it is sent to a near-line tape library is a common example.
Sources: en.wikipedia.org
president Donald Trump, FIFA suspended the ban. The Royal Belgian Football Association, Belgium manager Rudi Garcia, and UEFA were critical of the decision. Following the full-time whistle in the final, Argentina player Leandro Paredes was involved in altercations with Spain players Eric García and Gavi. While FIFA initially reported a red card for these incidents, the organization later confirmed that Paredes was not punished at the time. The following suspensions were accumulated during the tournament:
=== Isotopologues === Fludalanine (3-Fluoro-D-alanine-2-d): 3-fluoroalanine that has been deuterated at C2. This molecule was a promising antibiotic candidate that inhibited alanine racemases, which are integral to bacterial cell wall synthesis. At high concentrations, bacteria use fludalanine itself for cell wall synthesis. The compound ultimately failed clinical trials due to toxic metabolites.
== History == In traditional oil painting as practiced by the Renaissance painter, skin glue was used to seal the canvas. This is necessary because the linseed oil that forms the base of most oil paint contains linolenic acid that will destroy the canvas fibers over time. Renaissance artists also knew that pure size (hide glue) became brittle once dry, and would mix it with oil and chalk to make a "half-ground" for canvases. Pure hide glue was usually applied only to rigid supports like panels. Though this does help to seal the canvas or panel, artists still applied a layer of "oil ground", which was often lead-based paint, in order to provide a binding layer for the final oil paint to adhere to.
=== Microstructure and crack propagation === During the dentinogenesis process, the odontoblast cells retreat from the DEJ to the outer lining of the pulp, leaving behind microtubules filled with cytoplasmic extensions and depositing intertubular dentin (ITD) in its place. ITD comprises the bulk of the dentin and, similarly to bone, is a matrix composite of tablet-shaped hydroxyapatite nanoparticles wrapped around collagen fibers. The mineralized collagen fibers are arranged in layers oriented perpendicular to the direction of the dentin microtubules which are lined with peritubular dentin (PTD), a 1-2 μm thick layer of hydroxyapatite tablets with no preferred orientation and lacks any supporting collagen fibers. The hydroxyapatite tablets within the ITD were found to be compressed along the crystallographic c-axis due to tight interaction between the tablets and the collagen fiber. Tablets aligned parallel with the collagen fibers experience a significant increase in compressive stress of around 90 MPa and, for crack formation to occur, tensile stresses must first overcome this residual compressive stress. Since typical mastication stresses do not exceed 40 MPa, the ITD prevents cracks from forming during normal daily use and helps deflect cracks perpendicular to the dentin tubule and away from the pulp. Inelastic deformation of dentin primarily happens through microcracking. Crack propagation within dentin travels preferentially along the interfaces of the ITD layers.
{\displaystyle {\begin{cases}{\ce {^{244}_{96}Cm ->[{\ce {(\alpha,n)}}] ^{247}_{98}Cf ->[\epsilon][3.11 \ {\ce {h}}] ^{247}_{97}Bk}}\\{\ce {^{244}_{96}Cm ->[{\ce {(\alpha,p)}}] ^{247}_{97}Bk}}\end{cases}}}
Sources: en.wikipedia.org
It is registered as a pharmaceutical product in Russia, where it is typically supplied as a nasal solution. In most other countries it is not an approved drug and is traded as a research chemical instead. Approval status depends entirely on the jurisdiction involved.
Most published work uses intranasal administration, matching the route of the registered Russian formulation. Some animal experiments use intravenous or intraperitoneal injection. The route matters because the intact peptide is cleared rapidly from blood, so exposure differs between methods.
A purity value describes the share of the powder accounted for by the target peptide, usually by high-performance liquid chromatography. It does not confirm that the sequence is correct, which requires mass spectrometry or amino acid analysis. Purity and identity are separate checks.
Suppliers normally quote a percentage of total chromatographic peak area, most often from reversed-phase HPLC. That figure says nothing about what the remaining percentage contains, and it depends on the detection wavelength used. A mass spectrometry result is a separate and stronger check on identity.